How to prepare your computer
Step-by-step guide for Mac users
Introduction
The PSI secure browser must be installed before the ISE test. Follow the steps below.
Step 1: Download
Download the .pkg file from the link below.
Save the file somewhere you can easily access later, such as your desktop.
Step 2: Prepare to install the browser
Double-click on the .pkg file. This will open the installation wizard.Click 'continue' to proceed through the wizard. Read the terms and conditions and then click 'agree'.
Click 'change install location' and ensure 'install for me only' is selected if you are installing on a personal computer.
Step 3: Install the browser
You will need approximately 500 MB of free space to install the browser.
Click 'install' and wait until the browser finishes installing. You now no longer need the .pkg file and can move it to the recycle bin.
Step 4: Set up the browser
The secure browser will now be on your desktop.
Double-click on the secure browser icon. Click 'OK' to allow access to your camera. Click 'OK' to allow access to your microphone.
You will also need to allow screen recording. Follow the on-screen instructions to open system preferences, click on the lock icon, enter your computer password and then enable the PSI secure browser. You will need to restart the secure browser after this step.
Step 5: System requirements
You will need to complete the security checks.
Disconnect any extra monitors. You can only use one monitor while the browser is running.
You will need to close down any open applications. Click on ‘terminate all these applications’ to close all open applications. You can also close each application one by one.
Very important: Before you click 'next', write down the below exit code as you will need it in step 7.
Exit code: TB%VmEh9>SjF
When both sections show 'pass', click 'next'.
Step 6: Log-in to ATLAS Cloud
Log in to the browser with your username and password.
Check that you pass all the system requirements.
Step 7: Close the Browser
To close and exit the browser you will need your exit code. Type in the code exactly as it appeared in step 5 (it is case sensitive). You can then close the browser.
You have now successfully set up the secure browser. You will need to log in again when you take your test.
